ValueError thrown when connecting to WiFi on Nano RP2040

[sebromero]

On Arduino Nano RP2040 connecting to WiFi fails due to line s.config(pm=0xA11140) which throws ValueError: AP required. I'm on MicroPython 1.26.1 and Nina FW 2.0.0.

[ebolisa]

On Arduino Nano RP2040 connecting to WiFi fails due to line s.config(pm=0xA11140) which throws ValueError: AP required. I'm on MicroPython 1.26.1 and Nina FW 2.0.0.

You know that line is for a Rpi pico w? Just comment it out.

[sebromero]

@ebolisa I figured, but since this package is supposed to be compatible with Arduino Nano RP2040 Connect, it might make sense to check for the board in addition to the platform and skip that command for that board.

[ebolisa]

@ebolisa I figured, but since this package is supposed to be compatible with Arduino Nano RP2040 Connect, it might make sense to check for the board in addition to the platform and skip that command for that board.

I recall one of the files does check for the type of board and, based on the result, the right pin for a LED is selected.

[peterhinch]

Unfortunately my attempts to run MicroPython on the Arduino Nano RP2040 Connect were a failure, even after working with Jimmo. I gave up in disgust and consigned the thing to the bin.

I would be open to a PR that fixes issues with this platform.

[sebromero]

Thank you @peterhinch , I'll give it a shot.