Cannot save Memory Information limit, e.g. change from enabled to disabled 3GB.

[einsteinagogo]

Cannot save Memory Information limit, e.g. change from enabled to disabled 3GB.

tried v1.36, v1.37, v1.38

v1.35 is stable and works, other versions complain about Submit Failed using RPi4 (MicroSD cards) and RPi4 CM4 (eMMC)

[kpinc]

I have the same problem on 1.41, although most of my attempts were on an earlier version I don't know the version number for.

(Not that it should matter, but when I did grub-install I did not have the efivarfs module loaded, so have to use the efi menu to add the grub efi binary to the list of boot choices.)

It seems it just "does not save". When I change the setting, it says a setting has changed and I must press F10, and then Y. Even though I do that, after pressing Esc to exit the "Advanced" menu it still says a configuration has changed. (I think that's the spot.) And then Esc again to exit the Rpi configuration menu, at that point (IIRC) the system again says I must press "Y" to save. If instead of Esc I press F10, and Y, this does not matter. It also does not matter if I power cycle after the very first save. Anyway, when it comes time to exit the menu system entirely and I choose "Continue", it says a reset is required because configuration changed and press any key (IIRC) to save.

As you can see, I've tried every combination I can think of. Nothing works.

I also upgraded the eeprom to the latest version. (By booting into the raspbian OS and upgrading everything.) That didn't change anything either.