You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When printing with T0 the Z axis moves to the first layer starting position and drags the homing sensor along the build plate. This does not occur with T1 or T2 because the slicer calls the tool before raising the axis. This behavior has been in superslicer for a while and has caused me to lose a homing probe.
Is it possible to change the start gcode to call the tool before raising the bed for all tools?
Version
Version: 2.5.59.13
Operating system type + version
Windows 11 23H2
Behavior
When printing with T0 the Z axis moves to the first layer starting position and drags the homing sensor along the build plate. This does not occur with T1 or T2 because the slicer calls the tool before raising the axis. This behavior has been in superslicer for a while and has caused me to lose a homing probe.
Is it possible to change the start gcode to call the tool before raising the bed for all tools?
Project File (.3MF) where problem occurs
Project file and gcode files for T0 and T1 are attached
GRIDFINITY-slitting-saw-box.zip
The text was updated successfully, but these errors were encountered: