Dear the Gift team,
I am reaching out because my group ica job keeps being killed. I have allocated #SBATCH --mem=100G for the job. I would greatly appreciate any suggestions for that. And the job output is as follows:
Starting Analysis
GETTING DATA REDUCTION PARAMETERS----------------------
Reduction step 1 starts with 1 groups and gets reduced to 1 groups
-New Group #1: 1 groups will be concatenated to form the new group.
Each of the to be concatenated groups is made up of 28840 BOLD timepoints
The new group will have a total of 28840 stacked BOLD timepoints
This group will then be reduced to 20 principal components
END GETTING DATA REDUCTION PARAMETERS----------------------
Checking to make sure parameters are correct...
Checking mask
Checking principal component parameters
Done with parameter error check
STARTING DATA REDUCTION (PRINCIPAL COMPONENTS ANALYSIS)
--Extracting principal components for data reduction( time #1 )
--Doing pca on Subject #1 Session #1
/.singularity.d/runscript: line 3: 2816243 Killed /opt/matlab/R2018b/bin/matlab "$@"
Complete
slurmstepd: error: Detected 1 oom-kill event(s) in StepId=5196403.batch cgroup. Some of your processes may have been killed by the cgroup out-of-memory handler.
Dear the Gift team,
I am reaching out because my group ica job keeps being killed. I have allocated #SBATCH --mem=100G for the job. I would greatly appreciate any suggestions for that. And the job output is as follows:
Starting Analysis
GETTING DATA REDUCTION PARAMETERS----------------------
Reduction step 1 starts with 1 groups and gets reduced to 1 groups
-New Group #1: 1 groups will be concatenated to form the new group.
Each of the to be concatenated groups is made up of 28840 BOLD timepoints
The new group will have a total of 28840 stacked BOLD timepoints
This group will then be reduced to 20 principal components
END GETTING DATA REDUCTION PARAMETERS----------------------
Checking to make sure parameters are correct...
Checking mask
Checking principal component parameters
Done with parameter error check
STARTING DATA REDUCTION (PRINCIPAL COMPONENTS ANALYSIS)
--Extracting principal components for data reduction( time #1 )
--Doing pca on Subject #1 Session #1
/.singularity.d/runscript: line 3: 2816243 Killed /opt/matlab/R2018b/bin/matlab "$@"
Complete
slurmstepd: error: Detected 1 oom-kill event(s) in StepId=5196403.batch cgroup. Some of your processes may have been killed by the cgroup out-of-memory handler.