Board Bring Up

If you have a board, either from us, or you've built one yourself, one way to test it is below:

Install and Run Arduino IDE

Arduino IDE download

Install the ESP8266 or ESP32 Board Support Software (firmware)

• Go into Tools->Board->Boards Manager and paste the appropriate URL for board support.
• ESP8266 https://arduino.esp8266.com/stable/package_esp8266com_index.json
• ESP32 : https://raw.githubusercontent.com/espressif/arduino-esp32/gh-pages/package_esp32_index.json
• Use the latest version for ESP32
• Use 2.4.0 only for ESP8266!

Install the ESP8266 or ESP32 Sketch Data Upload tool

** Exit Arduino IDE if running ** Install the ESP8266 or ESP32 Sketch Data Upload tool by unpacking it into your ~/Arduino/tools folder, if tools does not exist, create it and put the unzipped folder into tools (with an 's') *** ESP8266 Sketch Data Upload Tool Download *** ESP32 Sketch Data Upload Tool Download

Clone the latest copy of the #FujiNet code from github.

#FujiNet Github Repository

Open esp32/tests/config. (This will work for both boards)

• Change line 4 define to ESP8266 or ESP32 depending on your board
• Enable debugging if you want to receive it.

Connect your board to the USB port.

• Use the Upload function to upload the code to the board.

• Use the Tools->ESP8266 (or ESP32) Sketch Data Upload Tool to upload the data in the data/ directory (the ATR image) ** This happens automatically, just select the Data Upload Tool and the process will start

• You can then connect the #FujiNet to the Atari, and attempt to boot.

IF all goes well, you will see the Network Configuration screen.

• Select your network, enter password if needed.

• at the host prompt, enter fujinet.online and press RETURN.

• Select a disk image with the arrow keys, and RETURN to select.

• Before pressing RETURN, optionally hold down OPTION if BASIC is to be disabled.

Notes:

• for SparaDos SDX, use COLD /N to reboot and FujiNet should then load.
• for U1MB users ensure BASIC is disabled