A powerful, visually refined Infrared Signal Generator and Analyzer application for the Flipper Zero. Designed with a high-tech aesthetic and smooth animations.
- Variable Frequency: Generates IR signals with precise frequency control from 30kHz to 60kHz.
- Dynamic Animation: Features a "Crazy Mode" spectrum animation that reacts violently during transmission, visualizing the signal output.
- External Module Support: Automatically detects and switches to 5V external IR modules (pin PA7) for high-power transmission.
- Smart LED Feedback: RGB LED indicates frequency range (Red: <35k, Green: <42k, Blue: <50k).
- Spectrum Analyzer: A smooth, sine-wave based spectrum animation scans for signals ("Calm Mode") and reacts dyamically when a signal is detected ("Excited Mode").
- Frequency Detection: Decodes incoming IR signals and displays the detected protocol frequency in real-time.
- Auto-Sync: Automatically captures the detected RX frequency and applies it to the Generator, allowing for immediate re-transmission.
| Button | Action |
|---|---|
| Left / Right | Decrease / Increase Frequency (1kHz steps) |
| OK | Start / Stop Transmission (TX Mode) |
| Long Press UP | Switch to Signal Searcher (RX) Mode |
| UP | Return to Generator (TX) Mode |
| Back | Exit Application |
- High-Tech UI: Custom frames, bottom status bands, and clean typography.
- Reactive Animations: The interface feels alive with wave animations that respond to the device's state (Idle, Scanning, Transmitting, Receiving).