A simple input board to interface multiple connectors with DIY projects. I use it mainly as connector boards for prototyping tube amps, which are wired point to point. Adding flimsy cables with connectors soldered to them was and would be tedious. Also this makes it possible to securely attach oscilloscope probes on the test holes.
- 3.5mm Stereo Jack
- 2 Stereo Chinch/RCA connectors (for input/output)
- 4.4mm Differential Pentaconn connector, because i like it and want to push it.
- 4 Mono Differential XLR connectors (for input/output). One could use each of these as a single stereo Jack
To interface these connectors to your DIY project you need a few JST_EH P2.50mm connectors and cables, which are the (it looks like to me) standard for cheap knock off DIY connectors in sets on eBay.
You could also just solder wires to the holes corresponding to the input jack.
The XLR connectors wre wired somewhat weirdly, like you can see in the next picture:
As you can see, the top pins are the hot pins and the bottom pins are the cold pins. Use this as you like. The pin 1 of the XLR (used for ground or Earth) is connected only to the GND plane on the XLR side. To connect this to the GND of the single ended Jacks (RCA and 3.5mm) and the pentaconn one you have to solder the little "Earth_Con" jumper.
The switched contacts of the 3.5mm jack are broken out, too.
The 3D models of the connectors are not in this repository, you can grab these on GrabCAD.