1.4.12

[1.4.12]

Added

• Webui : Show wifi ssid scan
  additional input for timeout to reset if network reconnect failed
  refactoring and change layout of buttons
  dock-menu (drag-n-drop)
• Network : wifi ssid scan added

Fixed

• network : reconnect network if dhcp server is not working at reset from vdmot
  timeout for reset if network reconnect failed (power on behaviour)
• update WTH : reset delay after update to show website correct (seen with wifi connection)

1.4.10

[1.4.10]

Added

• Webui : Show information if stm failed
• PI Control : deadband added

Fixed

• Mqtt : reconnect mqtt if control setup is saved to subscribe topics again
• SNTP : connection improved

V1.4.9

V1.4.9
STM :

Fixed

• System : valves detection went sometimes wrong
  WTH32 :

Added

• HA discovery : temperature_state_topic added

V1.4.8

WTH :

Fixed

• Webui : if stm32 is not responding after reset an error message is displayed in config and config save button is enabled again
• Webui : manual set valve button on status page was not displayed after login.
• update : if the file-end is 256 byte aligned a verify error occurs during update stm after flashing

Changed

• Webui : display all temp sensors on status page if 'publish all temps' is enabled

Added

• Pi Control : actual pi control values will be saved in rtc ram and
  reloaded after reset by SW (will take by update or reboot with SW, not when power off/on or hardware reset)
• Webui : more in state info during calibration

STM :

Changed

• System : set the valves to previous % state after calibration

V1.4.7

[1.4.7]

Changed

• Webui : handling for login to save login parameters in browser password manager
• Webui : display temp sensor name on status page in temp1 and temp2

Added

• WebUI : logout button

V1.4.6

• Mqtt : bugfix in topic generation
• Webui : disable config save button while loading

1.4.4

• Mqtt : publish ip added
  send initial value for valve/control/mode after boot.
  Discovery of 0.5 degree step with climate
• Control : Initial value for target temperature after boot

V1.4.3

[1.4.3]

Added

• STM : Boot0 ota : reduce Baudrate by div 2 if init failed. Retry 2 times
• Mqtt : discovery: climate and valve added
• Mqtt : tValue and tTarget will be resend by VDMot if received from a server and differs from the last one. ( Only if strict seperate topics is enabled)

V1.4.2

1.4.2

Changed

• Mqtt discovery: if valve name und temp name is empty then the idx-number is set as name
  delete last topics (user can activate) in HA prior sending new discovery

Added

• STM : check for compatibility to WTH32 version

1.4.1

Changed

• Mqtt : blanks in valve name und temp name allowed

Added

• Mqtt : discovery for home assistant