Voltage clarification

[DipFlip]

The Serial Bus Servo Driver Board listed in the Bill of materials has a listed input of 9-12.6V but the listed power supply is 5V. Does it work just fine with the lower voltage too? Might a 12V power suppy work with these motors through that driver board too?

[dmosher42]

I may have misinterpreted the datasheet in my deleted comment.

[officemanager-cpu]

Unsubscribe

…

On Tue, Jan 6, 2026 at 2:37 PM Dee Mosher ***@***.***> wrote: *dmosher42* left a comment (TheRobotStudio/SO-ARM100#142) <#142 (comment)> I may have misinterpreted the datasheet in my deleted comment. — Reply to this email directly, view it on GitHub <#142 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/BZ7MFHSXQBBEMP2EOKZTR2D4FQFF3AVCNFSM6AAAAACODI2L42VHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZTOMJWGAZTSNJSGY> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>