IoT-Z Firmware

Default firmware of Module (C++)

Mode config Network

Connect on the network created by the module Pass: 123456789 (is the detault, but can be changed) Access the config page address: 192.168.4.1

Todo

• Add a RGB led for inform state
  • Yellow: Button reset Pressed
  • Red: Button reset Pressed for a long time (Format)
  • Blue: Config mode
  • Green: Slave mode
    • Blinking rapid: Trying to connect to WIFI AP
    • Blinking slowly: Trying to connect to Server UDP
    • Static: Ok and connected to the Server

Thanks to

@MarcioLaubstein for teaching me some C++ basics