Enable Reverse Camera

canbus.com.au

How to activate with Forscan

Hardware Required:

• mkI Fg Falcon with colour tft screen, **fitted with reverse camera + wiring harness **to FDIM plug underneath ICC Top Hat.
• OBD Adapter with MS-Can support
• Laptop

Software Required:

• Forscan with Extended License

Take a back up of your As Built Data.

It is always a good idea to take a backup of your vehicles data before modifying any configurations. This can be done in Forscan via the Module Configuration section.

1. Select the Module to be Backed Up, ie Front Display Interface Module(AS BUILT)
2. Flick over to ms-can on your switch when prompted.
3. Select Save & Save the .abt file
4. Select the Stop Icon to exit the configuration

Enable the Camera

The Reverse Camera Feature can be activated in the Module Configuration.

1. In Forscan under Module Configuration, Select the Module Standard Configuration, NOT the As Built Mode. Flick the ms-can switch when prompted.
2. Select the option for Reverse Camera and set it to Equipped
3. Cycle the Ignition if instructed to do so
4. Select the Stop Icon to exit the configuration
5. Test

Troubleshooting

If in need of help troubleshooting this, try the forscan.org forums, fordforums.com.au or email me at service [at] canbus.com.au

Forscan

• Forscan
Forscan is a Ford specific software compatible with various scantools.
• Forscan Tutorial
• How to use output control
• Modify Module As-Built Data
• How to access MS CAN bus with modified ELM327
• How to run FORScan on Linux
• Helpful Links