- Full compatibility with the MP2 ESC.
- Standard blue/black pill header arrangement (2, 20 x 0.1in headers with 0.6in spacing).
- Kicad BOM contains links to jlcpcb for rapid PCBA.
- Four layer design with two inner uninterupted ground planes.
- USB-C connector.
- CAN pin header.
- Input: +3.52V to +5.25V
- Output: +3.3V @ 1000mA
- Dimensions: 53.8 x 19.4 mm
- Headers: 2, 20x0.1in pins @ 0.6in spacing
- Schematic
- 8 Mhz oscillator
- LM1117 LDO Voltage Regulator (datasheet)
- BSD License
| ST-LINK | |
|---|---|
| Name | Connected to |
| GND | Ground plane |
| SWCLK | PA14 |
| SWDIO | PA13 |
| 3V3 | +3.3V rail |
| CAN Bus | |
|---|---|
| CAN1_TX | PB9 |
| CAN1_RX | PB8 |
| LEDs | |
|---|---|
| Blue_LED | PC9 |
| Green_LED | PC12 |
| Red_LED | 3.3v |
- The F405_pill_V1.0 has been deprecated.
- Xtal caps from 18pF to 12pF
- Separate the two LEDs from the single resistor
- CAN spike protection
- RC between GND and pb12 to stop false trips
- PC12->PA15 to drive LED
- Increased functionality of several header pins
- Review this document for pin changes
- Jumper to disable CAN termination resistor on bottom side of board
Questions? Contact this person.