NOTE: Confirmed working on RetroPie v4.3 and v4.4!! :D

retroTINK-setup (Should work for RGB-Pi users as well!)

A Setup script to install RetroTINK configs on a fresh RetroPie v4.3+

These all are setup for my Sony Trinitron KV-AR29M31 via Component input. Most are pixel perfect resolutions with correct timing/clocks.

A few were just too small on my screen for proper pixel perfect integer scaling, so i've done a little messing around so they look good with hardware scanlines but fill more of the screen.

HowTo:

Console/SSH into your fresh retropie install.

(NOTE: ssh can be enabled by either placing a blank ssh file in /boot/ or by configuring it from HDMI emulationstation before running this script).

Type/paste command (All one line)

wget https://raw.githubusercontent.com/Vykyan/retroTINK-setup/master/retroTINK-setup.sh -O - | sudo bash

Follow Instructions. (Make sure to change emulationstation theme to "tft-retrotink" once back in Emulationstation after reboot!

Currently supported Libretro Systems:

(Not emulator dependent, must be libretro/retroarch core) (Ex: snes will catch any SNES libretro core, ie, lr-snes9x,lr-pocketsnes etc)

• atari2600
• atari5200
• atari7800
• atarilynx
• fba
• fds
• gamegear
• gb
• gba
• gbc
• genesis/megadrive
• mame-libretro
• mastersystem
• msx
• n64
• neogeo
• nes
• ngp
• ngpc
• pc
• pcengine
• pcenginecd
• psx
• sega32x
• segacd
• snes
• supergrafx
• virtualboy
• wonderswan
• wonderswancolor

Currently supported OTHER emulators/ports:

• advmame (relies of advmame inbuilt support for changing resolutions)
• doom
• quake