PSoC Creator MCU Projects

This repository contains several PSoC Creator projects for MCU development,
including sensor tests, motor tests, and the final integrated project.

The final project (Endedition_on_mcu) is designed to run together with the PC-side control software.

---

Project Structure

• 2Motorlaufen/
  Test project for motor control.

• DS18B20temperatur_sensor_test/
  Test project for the DS18B20 temperature sensor.

• VL6180X_Distance_Test/
  Test project for the VL6180X distance sensor.

• Endedition_on_mcu/ (main application)
  Final integrated project combining motors, sensors, and communication.
  This project works together with the PC-side software.

---

Prerequisites

• PSoC Creator 4.x (same version recommended across collaborators)
• PSoC Programmer (installed with Creator/KitProg3)
• Proper board drivers installed (KitProg3 / Bootloader)

---

How to Build

1. Clone this repository: '''bash git clone https://github.com/rruiying/CDC_SET_UP_Programm_on_MCU.git'''

2.Open the workspace (.cywrk) in PSoC Creator: For main usage: open Endedition_on_mcu/Endedition_on_mcu.cywrk For experiments: open the corresponding test project

3. In Workspace Explorer, right-click the project → Set as Active Project

4. Build: Build → Clean Project Build → Build Project

5. Programming the MCU Option A: Inside PSoC Creator Select the correct Target Device in the toolbar Ensure the board is connected Debug → Program (or right-click project → Program)

   Option B: Using PSoC Programmer Open PSoC Programmer Select interface (KitProg3) and device Load the generated .hex from ...<project>.cydsn\CortexM0p\ARM_GCC_xxx\Debug
   Click Program

6. PC-Side Software Option A: Using Option A: Serial terminal (e.g., PuTTY) Open the correct COM port in Port rate: 115200 Type HELP to see available commands

   Option B: Using PC-Programm The Endedition_on_mcu project is designed to work together with the PC-side control application. Communication method: USB-CDC (virtual COM port) Features: exchange commands, read sensor data, control motors via PC interface Repository: CDC_Set_Up_Control_Programm Clone and build the PC-side application from the above repository to run the complete system.