Configure WiFi settings using the Web UI

Jump to bottom Edit New page

Robert van den Breemen edited this page Feb 28, 2021 · 11 revisions

After first flash, or, when you alter your WiFi network, then you need to configure your wifi settings.

Wait for the ESP to go into the AP config mode.
Open your WiFi setting (smartphone or computer)
Then select OTGW-XX-XX-XX-XX-XX
A configuration screen should pop up. If this does not happen, just go to 192.168.4.1
Now simply configure your WiFi setup.
After the device is connected to WiFi, connect to the WebUI and goto http://otgw.local
Known issue: Multicast DNS doesn't work for all, then find out the IP address by looking at the serial output (9600 baud) while connected to USB. It will tell you the IP address on boot

In the Web UI you can go to Settings by clicking:

Read more on how to continue to setup the OTGW firmware on the ESP 8266.

You are welcome to contribute to my projects, just do a pull request or give feedback through issues.

Navigation is the right of this! -->>>>>>>>>