LEDs
On the board with the ESP32 - besides the OLED display - also two green LEDs* are controlled. These LEDs are already installed on the breakout board from blinkyparts.com.
-
LED1 (left) for status network:
- Blinking: WLAN is connected, but NTP and MQTT (if activated) are not connected.
- On: WLAN, NTP and MQTT are connected.
- Off: WLAN is not connected.
-
LED2 (right) for inverter status:
- Blinking: All inverters are reachable, but are not producing.
- On: All inverters are reachable and producing.
- Off: At least one inverter is not reachable. Note: Only inverters with polling enabled are considered.
* Note on hardware:
- LED1 is controlled via pin G25.
- LED2 is controlled via pin G26.
0a 00 20 01 00 0c 08 fc 07 a3 00 0f 09 e2 00 1e 06 4a 00 14 0a 55 00 14 0a c8 00 0a 09 e2 10 03 13 88 12 c0 00 14 13 ec 00 14 12 8e 00 32 14 50 00 32 20 00 00 01 30 03 02 58 09 e2 07 a3 13 9c 13 56 40 00 07 d0 00 10 50 01 00 01 13 9c 01 90 00 10 00 00 60 00 00 01 09 e2 0a 5a 02 15 80 01 00 00 08 5b 01 2c 08 b7 09 41 09 9d 01 2c 00 64 90 00 00 00 00 5f b0 00 00 00 01 f4 00 5f 70 02 00 01 27 10 a0 02 00 00 00 00 d8 8b