SW_WinSDcard
A normal Windows-PC can not access the the Raspberry Pi (Linux) partition because it is formatted as ext4 (or btrfs). But the BOOT-partition is formatted as FAT32 which Windows can read and write.
The idea is to move the configuration file telex.json to the BOOT-partition and replace the original file with a symlink that the piTelex program can access it.
sudo mkdir /boot/config/
sudo mv /home/pi/piTelex/telex.json /boot/config/
ln -s /boot/config/telex.json /home/pi/piTelex/telex.jsonWith this change the Windows user sees a config folder on the SD-card and can change the telex.json with notepad (or any better editor like notepad++)
- Overview
- Electronics for TW39 Current Loop
- Electronics for ED1000
- Electronics for V.10
- SEU-M Board
- PCB Layouts
-
Local use
-
i-Telex
-
Advanced Topics
-
Tips, Tools & Gadgets
-
TW39 (current loop)
-
ED1000 (FSK modulation)
-
V.10 (TeKaDe FS200, FS220)
-
SEU-M-board based
- with Austrian AGT (Ö-AGT, current loop)
- as replacement for SEU-B card inside LO2000, LO2001, LO3000